LM4301TADDK PFXLM4301TADDK Touch Membrane Front Overlay

Order each part separately is available

Be aware of the following items when building the LM4301TADDK PFXLM4301TADDK Protective Film Touch Panel LT into an end-use product:
• The LT unit's rear face is not approved as an enclosure. When building the LT unit into an end-use product, be sure to use an enclosure that satisfies standards as the end-use product's overall enclosure.
• The LM4301TADDK PFXLM4301TADDK Protective Film Touch Digitizer Glass LT unit must be used indoors only.
• Install and operate the LM4301TADDK PFXLM4301TADDK Front Overlay Touch Membrane LT with its front panel facing outwards.
• If the LT is mounted so as to cool itself naturally, be sure to install it in a vertical panel. Also, it's recommended that the LT should be mounted at least 100 mm away from any other adjacent structures or machine parts. The temperature must be checked on the final product in which the LT is installed.
• For use on a flat surface of a Type 4X (Indoor Use Only) and/or Type 13 Enclosure.

5.7" Operator Interface Plus Control LM4301TADDK PFXLM4301TADDK Touch Screen Panel Front Overlay LT4000M Features:
• 5.7-inch (QVGA 320x240) Stand Alone Graphic Controller
• Ladder logic for simple machine control
• Built-in 16 discrete inputs, 16 outputs and up to 3 EXM modules
• All-in-one operator interface plus control solution reduces wiring, system cost, maintenance cost and space.
• Ethernet port for data management
• Serial port to communicate to temperature controllers.