LM4201TADAK PFXLM4201TADAK Touch Glass Overlay

Order each part separately is available

The following rules must be applied when wiring a LM4201TADDC PFXLM4201TADDC Touch Membrane Protective Film LT:
 Input/Output and communication wiring must be kept separate from the power wiring. Route these 2 types of wiring in separate cable ducting.
 Verify that the operating conditions and environment are within specification.
 Use proper wire sizes to meet voltage and current requirements.
 Use copper conductors.
 Use twisted-pair, shielded cables for analog, and/or fast Input/Output.
 Use twisted-pair, shielded cables for networks, and fieldbus.
 For the power connector, refer to DC power supply wiring diagram.
 When terminals A2 and B2 (signal name: Q1, Q0) are wired to external I/O, use the same power source for external I/O and the LM4201TADDC PFXLM4201TADDC Front Overlay HMI Panel Glass LT. Refer to Power Supply Connections.
 If you use a temperature sensor with thermocouple inputs, make sure you use the compensation cable.
 Prevent temperature changes to the thermocouple connection terminal. Correct temperature measurement may not be possible if the thermocouple cold junction (LT's thermocouple compensation wiring to the connection terminal) experiences temperature changes.

LM4201TADAK PFXLM4201TADAK Maintenance
 NEVER touch a live power terminal. Doing so could cause an electrical shock or a machine malfunction.
 To prevent an electrical shock, unplug the LM4201TADAK PFXLM4201TADAK Touch Digitizer Glass Front Overlay unit's power cord before either cleaning the LT or attaching/detaching the power terminal attachment screws.
 Do not connect or disconnect Host and LM4201TADAK PFXLM4201TADAK Touch Screen Protective Film unit communication cables while the LT is turned ON.
 Do not replace the LM4201TADAK PFXLM4201TADAK Front Overlay Touch Panel unit's battery yourself. The LT uses a lithium battery for backing up its internal clock data and the battery may explode if it is replaced incorrectly. When replacement is required, please contact your local LT distributor.