MT8100i Touch Screen Monitor Protective Film Replacement

Order each part separately is available

Environmental Considerations

Care should be taken when locating MT8100i Touchscreen Front Overlay behind the unit to ensure that AC power wiring, PLC output modules, contactors, starters and relays, and any other source of electrical interference are located away from the back of the unit. Particular note should be taken to the position of variable speed drives and switching power supplies. Their input and load cables should be screened to a central star earth point.

Weinview touch screen MT8100i Protective Film Touch Panel is designed for use in factory environments, capable of operating within temperatures ranging from 32 to 113 °F (0 to 45 °C), typical of most industrial settings. It may not be suitable for certain outdoor applications, so it is advised to consult the factory for recommendations on outdoor usage. There is a front bezel of the MT8000i Series, ensuring that when properly installed in the panel, the panel's rating remains intact, preventing fluid entry during washdowns.

Do not operate HMI Weinview MT8100i Protective Film Touch Screen Glass in areas with explosion hazards from flammable gases, vapors, or dust. Additionally, the unit should not be installed in locations with rapid temperature changes or high humidity, as this can cause condensation inside the device. Avoid environments with severe mechanical vibrations or shocks during installation because it will do harm to MT8100i Front Overlay Touch Digitizer.