IPC477E PRO 6AV7251-5FC35-0GA0 HMI Touch Glass Replacement

Notice

During operation, please pay attentions to the Siemens 6AV7251-5FC35-0GA0 Touch Panel TFT displays because of the burn-in effect and backlighting. The brightness of the backlighting deteriorates over the course of the Simatic 6AV7 251-5FC35-0GA0 Touch Screen's service life. A permanent picture with bright screen objects leads to a burn-in effect. If this happens, use a screen saver to extend the life of the IPC477E PRO 6AV72515FC350GA0 Touch Screen Monitor and the backlighting and to prevent the burn-in effect.

At present, the manufacturing process of modern displays does not guarantee that all pixels of the display will be perfect. A small number of defective pixels in the 6AV7251-5FC35-0GA0 Touch Membrane is therefore unavoidable. This does not present a functional problem as long as the defective pixels are not bunched in one location.

If the 6AV7 251-5FC35-0GA0 Touch Digitizer Glass is subjected to low temperatures or extreme fluctuations in temperature during transportation, as is the case in cold weather, for example, moisture can build up on or inside the device (condensation). In order to prevent damage to the Simatic IPC 477E PRO 6AV72515FC350GA0 HMI Touch Glass, store it in a dry place, bring it to room temperature before starting it up, do not expose it to direct heat radiation from a heating device. If condensation develops, wait approximately 12 hours or until the Siemens 6AV7251-5FC35-0GA0 MMI Panel Screen is completely dry before switching it on.