P50GAP40x00MxxxXXX P50GAP40x00MxxxXXX-0xxxxxxxxxx Touch Digitizer Glass Front Overlay

P50GAP40x00MxxxXXX P50GAP40x00MxxxXXX-0xxxxxxxxxx Front Overlay Touch Membrane Controller P500 maintenance and servicing

• The Lenze drive and automation components are maintenance-free. Nonetheless, you have to carry out a visual inspection at regular and sufficiently short intervals considering the ambient conditions.
Check the following:
• Does the environment still meet the operating conditions specified in the "Technical data" chapter of the product catalogue?
• Is the heat dissipation impeded by dust or dirt?
• Are the mechanical and electrical connections still okay?
• If the ambient air is polluted, the cooling surfaces may become dirty or the air vents may be obstructed.
Therefore, clean the cooling surfaces and air vents periodically under these operating conditions. Do not use sharp or pointed tools for this purpose!
• Heatsinks get very hot during operation.
Before working on the P50GAP40x00MxxxXXX P50GAP40x00MxxxXXX-0xxxxxxxxxx HMI Touch Glass Protective Film Controller P500 devices, check the heatsink temperature.
Flammable material or substances must not be placed near the heatsink or get to it.
• After disconnecting the system from the supply voltage, do not touch live device parts and power terminals immediately because capacitors may be charged.
Observe the corresponding information plates on the P50GAP40x00MxxxXXX P50GAP40x00MxxxXXX-0xxxxxxxxxx Touch Screen Panel Front Overlay Controller P500 device.