APL3700-TD-CM18-2P APL3700-TD-CM18-4P Pro-face Front Overlay Touch Glass

Order each part separately is available

Be sure to follow the instructions given below to ensure the safe use of the APL3700-TD-CM18-2P APL3700-TD-CM18-4P Protective Film Touch Glass PL.
 Before opening the APL3700-TD-CM18-2P APL3700-TD-CM18-4P Touch Panel Front Overlay PL's protective cover, be sure to turn the unit's power OFF. This is because the PL's internal parts carry high voltages.
 To avoid fires or electrical hazards, do not modify the product in any way.
 Before replacing the 100V unit's backlight, be sure to turn the unit's power OFF to avoid electrical shocks. (Note: Do NOT attempt to replace the 24V unit's backlight)
 Do not create touch panel switches that are used to either control or ensure the safety of equipment and personnel. Mechanical switches, such as an emergency stop switch, a deadman (two-handed) start switch, etc., must be installed and operated via a separate system.
 If metal particles, water or other types of liquids contact any of the APL3700-TD-CM18-2P APL3700-TD-CM18-4P Protective Film Touch Screen Panel PL's internal parts, immediately turn the unit's power OFF, unplug the power cord, and contact either your dealer or Digital Electronics Corporation.
 Read and understand Chapter 4 “Installation and Wiring” thoroughly in order to select an appropriate installation location for the PL.
 Before either plugging in or unplugging a board or interface connector, be sure to turn the PL's power OFF.
 To avoid the possibility of electrical shock, be sure to connect the power cord to the PL before connecting it to the main power supply.
 To avoid fires or electrical shocks, do not use voltages beyond the specified range.
 To prevent a possible explosion, do not install the APL3700-TD-CM18-2P APL3700-TD-CM18-4P Touch Membrane Front Overlay PL in areas containing flammable gases.