GLC150-BG41-ADPK-24V GLC150-BG41-ADTC-24V Film Touch Screen

FAQ:

Question: How to replace the GLC150-BG41-ADPK-24V GLC150-BG41-ADTC-24V backlight?

Answer:

Use the following steps to change the Backlight. Be sure to use gloves.
1) Unplug the GLC's power cord from the power supply. Then, remove the GLC's power cord terminals from the power terminal block. (Fig. A)
2) Unscrew the GLC's two (2) top face attachment screws. (Fig. B)
3) Turn the unit so the display surface is facing down. At this time, be sure not to scratch or damage the display surface.
4) Insert a screwdriver into the hole located on the GLC unit's side face to open the case. (Fig. C)
5) Open the GLC150-BG41-ADPK-24V GLC150-BG41-ADTC-24V Touchscreen Panel Front Overlay unit and detach the backlight connector (Fig. D) At this time, do not remove the inside cover. (Fig. E)
6) Push the backlight's Lock Tab to the right to free the backlight, then pull it upwards and out of the GLC150-BG41-ADPK-24V GLC150-BG41-ADTC-24V Protective Film Touch Screen Monitor unit. (Fig. F)

8. Insert the new backlight and slide it into its slot until the Lock Tab can be clicked into place, and attach the new backlight's Power Connector to the inverter board.
9. To replace the GLC's rear cover, insert the cover's guide tabs into the case's guide slots and close the cover. Be sure that the Rear Cover Connector and the Front Unit Connector are correctly aligned. (Fig. G)