6FC5203-0AF11-2AA0 Membrane keypad keyboard

Order each part separately is available

General Information of Siemens OP010 6FC5203-0AF11-2AA0 Plastic Case Terminal Keypad
You can work in three different operating modes.

1."JOG" mode is used for the following preparatory actions:
• Reference point approach,i.e.calibration of the position measuring system of 6FC5 203-0AF11-2AA0.
• Preparing a machine for executing a program in automatic mode,i.e.measuring tools, measuring the workpiece and, if necessary, defining the work offsets used in the program.
• Traversing axes,e.g.during a program interruption.
• Positioning axes of 6FC52030AF112AA0 Operator Panel Keypad Housing.
• Select "JOG" and press the "JOG" key.

2."Ref Point" submode:
• The "REF POINT" submodel of 6FC5203-0AF11-2AA0 Membrane Keyboard Keypad Plastic Case is used to synchronize the control and the machine. For this purpose, you approach the reference point in "JOG" mode.
• Selecting "REF POINT" and press the "REF POINT" key of 6FC5 203-0AF11-2AA0.

3."REPOS" submode:
• The "REPOS" submode is used for repositioning to a defined position. After a program interruption (e.g.to correct tool wear values)move the tool away from the contour in "JOG" mode.
• The distances traversed in "JOG" mode of 6FC52030AF112AA0 HMI Cover Keypad Membrane are displayed in the actual value window as the "Repos" offset.

Note:
• Press the "CYCLE STOP" key of 6FC5203-0AF11-2AA0 Switch Membrane.
• Machining stops immediately. Individual program blocks are not executed to the end. On the next start, machining is resumed from the point where it left off.

Stopping machining:
• Press the "CYCLE STOP" key of 6FC5 203-0AF11-2AA0.
• Machining stops immediately. Individual program blocks are not executed to the end. On the next start, machining is resumed from the point where it left off.

Canceling machining:
• Press the "RESET" key of 6FC52030AF112AA0 Housing Operator Keyboard.
• Execution of the program is interrupted. On the next start, machining will start from the beginning.