MT509LV3EV MT509LV3CN MT509LV4CN Touch Digitizer Front Overlay

Precautions

Please observe the following precautions when installing the Weintek Weinview MT500 Series. Failure to comply with these restrictions could result in loss of life, serious personal injury, or MT509LV3EV MT509LV3CN MT509LV4CN Touch Screen Monitor Protective Film damage.
1. Do not operate the device in areas subject to explosion due to flammable gases, vapors, or dusts. It will also do harm to MT509LV3EV MT509LV3CN MT509LV4CN Touchscreen Front Overlay.
2. Do not connect the unit to an AC power source. You will cause permanent damage to it.
3. Do not attempt to use a DC power supply that does not meet the power requirements. You may cause malfunction or permanent damage.
4. Do not power the HMC with a DC power supply used for inductive loads or for input circuitry to the programmable logic controller. Severe voltage spikes caused by these devices may cause the damage to MT509LV3EV MT509LV3CN MT509LV4CN Protective Film Touch Screen Tablet.
5. Care should be taken when locating Weinview HMI MT509LV3EV MT509LV3CN MT509LV4CN Front Overlay MMI Panel Screen behind the device to ensure that AC power wiring, PLC output modules, contactors, starters, relay and any other source of electrical interference are located away from the unit. Particular care should be taken to locate variable speed drives and switching power supplies away from the MT500 Series.