MT6071iP Front Overlay HMI Case LCD Display Touch Digitizer

Order each part separately is available

Cautions

When you've assembled Weintek Weinview MT6071iP Screws, Power Supply Connector, Mounting Brackets, Front Overlay, Front Case, Touch Screen Glass, LCD Display Screen and Back Cover, you may encounter the following problems.

About the touchscreen calibration, if you have trouble with it, press and hold anywhere on the screen when HMI starts until it enters touchscreen calibration mode. If the display does not come on within 5 seconds of power up, remove power. In addition, a resettable fuse will protect against overcurrent faults in DC circuit and the resetting will take place after a period of time. Check wiring for proper connections and try to power up again. The system designer should be aware that devices in Controller systems could fail and thereby create an unsafe condition, it will damage the MT6071iP HMI Case, Protective Film, MMI Panel Screen, Power Supply Connector, Screws, LCD Display, Mounting Brackets and Gasket. Furthermore, electrical interference in an operator interface can lead to equipment start-up, which could result in property damage and/or physical injury to the operator.

Tips about cleaning HMI Weinview MT6071iP Gasket, Front Overlay, LCD Screen, Screws, Housing, Mounting Brackets, Touch Digitizer Glass and Power Supply Connector: disconnect the equipment from all power outlets before cleaning. Use only a damp cloth for cleaning. Do not use liquid or spray detergents. Never pour any liquid into an opening. This may cause fire or electric shock. After cleaning, you should keep MT6071iP Gasket, Protective Film, Touch Screen, LCD Display, Back Cover, Front Cover, Screws, Mounting Brackets and Power Supply Connector away from humidity.