P50GAP90300C4G0XXX P50GAP90300C4G0XXX-02S14415000 Front Overlay Touch Screen

Order each part separately is available

P50GAP90300C4G0XXX P50GAP90300C4G0XXX-02S14415000 Protective Film Touch Screen Panel Controller/HMI P500

• When selecting the installation site, be sure to observe the ergonomic position of the screen and pay regard to the incidence of light, which may cause reflections on the screen. Protect the device from direct sunlight since the housing may heat up strongly.
• During installation, there is a danger that the controller will fall out of the mounting cutout. You should therefore secure it to prevent this happening until all screw clamps have been fitted.
• During mounting, the gasket of the front frame is exposed and can be damaged.
Check the gasket to make sure it is undamaged before you install the P50GAP90300C4G0XXX P50GAP90300C4G0XXX-02S14415000 MMI Touch Screen Protective Film Controller P500 device.
Handle the gasket with care during mounting.
Protect the gasket from UV radiation.
• The P50GAP90300C4G0XXX P50GAP90300C4G0XXX-02S14415000 HMI Touch Screen Front Overlay Controller P500 device must be securely seated in the mounting cutout and the front panel seal must be correctly fitted. Otherwise, the class of protection IP65 will not be achieved on the front side of the device! (IP rating is not UL-approved.)
• A touchscreen does not comply with the Ergonomics Directive ZH 1/618. This is why it is only designed for short-time inputs and control functions. For longer inputs, connect an external keyboard.