P30GAH80300F3G0XXX-02S3C015000 P30GAH80300F3G8xxx Touch Digitizer Glass Front Overlay

P30GAH80300F3G0XXX-02S3C015000 P30GAH80300F3G8xxx Front Overlay Touch Membrane Controller P300 maintenance and servicing

• The Lenze drive and automation components are maintenance-free. Nonetheless, you have to carry out a visual inspection at regular and sufficiently short intervals considering the ambient conditions.
Check the following:
• Does the environment still meet the operating conditions specified in the "Technical data" chapter of the product catalogue?
• Is the heat dissipation impeded by dust or dirt?
• Are the mechanical and electrical connections still okay?
• If the ambient air is polluted, the cooling surfaces may become dirty or the air vents may be obstructed.
Therefore, clean the cooling surfaces and air vents periodically under these operating conditions. Do not use sharp or pointed tools for this purpose!
• Heatsinks get very hot during operation.
Before working on the P30GAH80300F3G0XXX-02S3C015000 P30GAH80300F3G8xxx HMI Touch Glass Protective Film Controller P300 devices, check the heatsink temperature.
Flammable material or substances must not be placed near the heatsink or get to it.
• After disconnecting the system from the supply voltage, do not touch live device parts and power terminals immediately because capacitors may be charged.
Observe the corresponding information plates on the P30GAH80300F3G0XXX-02S3C015000 P30GAH80300F3G8xxx Touch Screen Panel Front Overlay Controller P300 device.