Delta TP70P-RM0 TP70P-RM1 TP70P-RM2 Front Film Touch Panel

FAQ:

Question: How do I fix the problem if the Delta TP70P-RM0 TP70P-RM1 TP70P-RM2 Front Overlay Touch Screen Human Machine Interface (HMI) is unable to connect to the computer through the connection cable?

Answer:
Generally, the connection between the TP70P-RM0 TP70P-RM1 TP70P-RM2 Touch Panel Protective Film HMI and computer is established through a USB type B connection wire for uploading and downloading. The user has to configure the HMI in accordance with different computer operating systems. Go to Options > Configuration > Others > USB Download
1. For Windows XP, the upload/download mode should be set to 0 (normal mode).
2. For Windows 7, 8, or 10, the upload/download mode should be set to 1 (disk mode)
3. If the USB permission is restricted by the IT department, please set to mode 2 (CDC mode). If the connection between the TP70P-RM0 TP70P-RM1 TP70P-RM2 Touch Digitizer Front Overlay HMI and computer is not established before the beginning of the project, new settings won't be uploaded or downloaded. In this case, the user has to set up the system by pressing the system menu from the back of the TP70P-RM0 TP70P-RM1 TP70P-RM2 Protective Film Touchscreen Panel HMI.
Please follow the steps below.
1. Press the system menu button on the back of the TP70P-RM0 TP70P-RM1 TP70P-RM2 Touch Screen Monitor Front Overlay HMI for 2 to 3 seconds. When the button is pressed, the buzzer will respond with a "beep" as notification (this is normal, not a warning).
2. Upon entering the TP70P-RM0 TP70P-RM1 TP70P-RM2 Protective Film Touch Screen Panel Glass HMI system menu, press the screen to enter System Setting > Misc. > USBCommMode and set the mode as 0 or 1 or 2.
3. After setting up, press the top right corner to go back to the TP70P-RM0 TP70P-RM1 TP70P-RM2 Touch Panel Overlay HMI project screen.