FP2500-T42-24V Pro-face Front Overlay Touch Membrane

Notes on the FP FP2500-T42-24V Touchscreen Panel Protective Film unit's Liquid Crystal Display (LCD)
• The FP FP2500-T42-24V Front Overlay Touch Digitizer Glass unit's LCD contains a strong irritant. If the panel is damaged and the LCD unit's liquid contacts your skin, be sure to wash it with running water for at least 15 minutes. If any of this liquid should enter your eye, be sure to flush the eye with running water for more than 15 minutes and see a doctor immediately.
• The brightness of the LCD screen will depend on the screen's current display and the LCD unit's contrast adjustment. Any brightness variations that result are normal for FP2500-T42-24V LCD displays.
• There are minute grid points on the FP2500-T42-24V LCD surface. These points are not defects.
• The displayed color will look different when viewed from an angle outside the specified view angle. This is also normal.
• Displaying a single screen image for long periods of time can cause an afterimage to remain. To correct this, turn the FP2500-T42-24V Protective Film Touch Screen Monitor unit OFF for 5 or 10 minutes, then turn it ON again. This phenomenon is a common attribute of the LCD units and not a defect. To prevent this effect, you can:
- use the Display OFF feature, if the same image is to be displayed for a long period of time.
- change the screen display periodically to prevent the displaying of a single image for a long period of time.