6FC5203-0AF08-0AB2 Siemens TP015A Touchscreen and Terminal Keypad

Order each part separately is available

Preparation for mounting Siemens 6FC5203-0AF08-0AB2 Switch Membrane Touch Screen Tablet
Thanks to the tension jacks on the TP015A 6FC5 203-0AF08-0AB2 Operator Panel Keypad HMI Touch Glass, drill-holes or screw holes are not needed. This retaining method also affords a degree of protection IP65 (but only in conjunction with a circumferential seal and when the protective USB cap is fitted). If you want to combine the TP 015A 6FC52030AF080AB2 Touch Digitizer Glass Membrane Switch with a PCU and possibly a direct control key module, assemble the components before installing them on the mounting wall.

Mounting 6FC5203-0AF08-0AB2 Keypad Membrane HMI Touch Glass on the mounting wall
The clearance at the rear of the PCU of Siemens 6FC5 203-0AF08-0AB2 must be at least 10 mm to ensure sufficient ventilation. Permitted mounting position: deviating by up to 5 from the vertical. This value can be further restricted by installed components (PCU, video link receiver,...).

Procedure
1. Insert the assembled components of 6FC52030AF080AB2 Membrane Keypad Touch Screen Monitor (operator panel front and PCU) from the front into the panel cutout.
2. Secure the 6FC5203-0AF08-0AB2 operator panel front in the panel cutout from the rear using the twelve tension jacks by tightening the setscrews (torque 0.5 Nm).

Softkey labeling
User-specific functions can be assigned to the two vertical softkey bars. Printed labeling strips can be used to label the softkeys. Blank labels of 6FC5 203-0AF08-0AB2 Touch Screen Tablet Terminal Keypad are already factory-installed. DIN A4 films are available for preparing the vertical strips.