Siemens OP015 Membrane Keyboard for 6FC5248-0AF25-0AA0

Order each part separately is available

Front and rear side of 6FC52480AF250AA0 6FC5248-0AF25-0AA0
USB 1.1 to connect an external keyboard or mouse. Note that the electromagnetic compatibility of commercially available peripheral devices operated via the USB port is usually rated for office use only. For industrial use, components with a higher degree of certification are recommended. Two ribbon cables for connecting the PCU of 6FC5248-0AF25-0AA0 Membrane Switch:
• I/O-USB cable K1 (ribbon cable): All signals that are used for the display interface and the connection of operator panel fronts (e.g.supply voltages)
• Display cable K2

Preparation for mounting of 6FC5 248-0AF25-0AA0 Operator Panel Keypad
Thanks to the tension jacks on the OP 015 6FC5248-0AF25-0AA0 Operator Keyboard, drill-holes or screw holes are not needed. This retaining method also affords a degree of protection IP65 (but only in conjunction with a circumferential seal and when the protective USB cap is fitted).

Mounting 6FC5248-0AF25-0AA0 Membrane Keyboard Keypad on the mounting wall
The clearance at the rear of the PCU must be at least 10 mm to ensure sufficient ventilation. Permitted mounting position of 6FC5 248-0AF25-0AA0 Membrane Switch: deviating by up to 5 from the vertical. This value can be further restricted by installed components (PCU, video link receiver,...).
1. Insert the assembled components (operator panel front and PCU) from the front into the panel cutout.
2. Secure the 6FC52480AF250AA0 operator panel front in the panel cutout from the rear using the six tension jacks by tightening the setscrews (torque 0.4-0.5 Nm).