Lenze P300 LCD Display Panel Touch Membrane Front Overlay

Order each part separately is available

Lenze P300 LCD Display Screen Touch Membrane Front Overlay Controller P300 maintenance and servicing

• The Lenze drive and automation components are maintenance-free. Nonetheless, you have to carry out a visual inspection at regular and sufficiently short intervals considering the ambient conditions.
Check the following:
• Does the environment still meet the operating conditions specified in the "Technical data" chapter of the product catalogue?
• Is the heat dissipation impeded by dust or dirt?
• Are the mechanical and electrical connections still okay?
• If the ambient air is polluted, the cooling surfaces may become dirty or the air vents may be obstructed.
Therefore, clean the cooling surfaces and air vents periodically under these operating conditions. Do not use sharp or pointed tools for this purpose!
• Heatsinks get very hot during operation.
Before working on the Lenze P300 Protective Film LCD Display Panel HMI Touch Glass Controller P300 devices, check the heatsink temperature.
Flammable material or substances must not be placed near the heatsink or get to it.
• After disconnecting the system from the supply voltage, do not touch live device parts and power terminals immediately because capacitors may be charged.
Observe the corresponding information plates on the Lenze Front Overlay Touch Screen Panel Controller P300 LCD Display device.