IPC 477E 6AV7241-3KC35-0DA0 Touch Screen Film Replacement

Notes on mounting

The Simatic 6AV7 241-3KC35-0DA0 Touch Screen must be mounted securely. Inadequately dimensioned fasteners may cause the IPC 477E 6AV7241-3KC35-0DA0 Touch Panel to fall down. Serious physical injury may result. Make sure that fasteners are adequately dimensioned during installation. Make sure to consider the weight and the forces acting on the Siemens 6AV72413KC350DA0 HMI Touch Glass when dimensioning. This applies in particular to dynamic load of the device. All fasteners including mounting surfaces, support arm systems, and fastening elements such as screws must be able to carry at least four times the weight of the device. Observe any further statutory specifications applying at the location of use of the IPC477E 6AV7 241-3KC35-0DA0 Touch Membrane and further applicable regulations with regard to fastening the device.
If you are using a support arm system or a pedestal system that does not have protection or Enclosure Type 4X / 12 (indoor use only), then the protection and Enclosure Type 4X / 12 (indoor use only) are voided for the entire device. Spray and water jets as well as penetrating substances can then damage the Simatic 6AV72413KC350DA0 Touch Digitizer Glass. Only use a support arm system or pedestal system that has protection and Enclosure Type 4X / 12 (indoor use only).