EZ-S8C-FSC EZ-S8C-FC HMI Touch Digitizer Protective Film

FAQ:

Problem: Memory Card

Action: Make sure that the Flash Card is in top slot, and the RAM Card is in the bottom slot.

Problem: EZ-S8C-FSC EZ-S8C-FC Display Blank

Action:
1. EZ-S8C-FSC EZ-S8C-FC Display indicates “NO POWER UP SCREEN” If this message is displayed the panel battery needs to be replaced.
2. Display is blank. Push extreme upper left and extreme lower left touch cells on the front of the EZ-S8C-FSC EZ-S8C-FC panel (top and bottom of column 1 on panel.)
a. There is no change, the display remains blank. Indicates UNIT FAILURE, return for service.
b. Unit SETUP screen appears, screen is hard to read. Adjust screen contrast control for 6- or 8-inch units (10-inch and 15-inch units have no contrast adjustment).
c. Unit SETUP screen appears normal. The EZ-S8C-FSC EZ-S8C-FC Touchscreen Protective Film HMI unit has no user program — install the user program.

Problem: EZ-S8C-FSC EZ-S8C-FC Display hangs when the unit is powered up, “Initializing...” message remains on screen (unit has invalid RAM memory)

Action:
1. Remove power. While pressing extreme upper and lower left touch cells on the panel, reapply power.
2. You will now be in setup mode, press exit to enter run mode. The EZ-S8C-FSC EZ-S8C-FC screen will be blank.
3. Run EZ Series EZ-S8C-FSC EZ-S8C-FC Touch Panel Editor Programming Software. Select Panel > Clear Memory from main menu bar, or upload a new user program to the panel.