3480801-01 PS3651A-T42 Pro-face Touch Glass Overlay

Order each part separately is available

 Do not create PS-A 3480801-01 PS3651A-T42 PFXPS36NxAxxxxR touch panel switches that could possibly endanger the safety of personnel or equipment. A malfunction of the 3480801-01 PS3651A-T42 PFXPS36NxAxxxxR Touch Screen Monitor Protective Film PS-A unit, its I/O unit(s), cable(s), or other related equipment can cause unexpected output signals, leading to a serious accident. Be sure to design all important machine operation switches so they are operated via a separate control system, and not via the PS-A.
 Be sure to design your system so that a communication fault between the PS-A and its host controller will not cause equipment to malfunction. This is to prevent any possibility of bodily injury or equipment damage.
 After the PS-A 3480801-01 PS3651A-T42 PFXPS36NxAxxxxR Touch Membrane Front Overlay unit's backlight burns out the touch panel is still active, unlike the PS-A unit's “Standby Mode”. If the operator fails to notice that the backlight is burned out and touches the panel, a potentially
 dangerous machine operation error can occur. Therefore, do not create PS-A unit touch panel switches that may cause injury and/or equipment damage. If your PS-A unit's backlight suddenly turns OFF, use the following steps to determine if the backlight is actually burned out.
 Do not create PS-A 3480801-01 PS3651A-T42 PFXPS36NxAxxxxR touch panel switches to control machine safety operations, such as an emergency stop switch. Install these switches as separate hardware switches, otherwise, severe bodily injury or equipment damage can occur.
 Do not use the 3480801-01 PS3651A-T42 PFXPS36NxAxxxxR Protective Film Touch Panel PS-A as a warning device for critical alarms that can cause serious operator injury, machine damage or can halt system operation. Critical alarm indicators and their control/activator units must be designed using stand-alone hardware and/or mechanical interlocks.
 Do not use the 3480801-01 PS3651A-T42 PFXPS36NxAxxxxR Front Overlay Touchscreen PS-A with aircraft control devices, aerospace equipment, central trunk data transmission (communication) devices, nuclear power control devices, or medical life support equipment, due to these devices' inherent requirements of extremely high levels of safety and reliability.
 If the PS-A unit's “Backlight Control” is not set and the screen has gone blank, your backlight is burned out.
 If the PS-A unit's “Backlight Control” is set to Standby Mode and the screen has gone blank, and touching the screen or performing another input operation does not cause the display to reappear, your backlight is burned out.