MPCST11NDJ00T Magelis Front Overlay Touch Membrane
Schneider Magelis HMI MPCST11NDJ00T Touch Screen Monitor Protective Film Repair Part
For cabinet installation, it is necessary for the correct sized opening to be cut in the installation MPCST11NDJ00T Front overlay touch panel. The installation gasket and installation fasteners are required when installing the Smart MPCST11NDJ00T Touch screen glass protective film unit. When install the Schneider Magelis Smart MPCST11NDJ00T touch digiziter glass from overlay terminal, we should note that:
Ensure the thickness of the installation panel is from 1.6 to 10 mm (0.06 to 0.39 in).
All panel surfaces used should be strengthened. Due consideration should be given to the product’s weight, especially if high levels of vibration are expected and the product’s installation surface can move. Metal reinforcing strips can be attached to the inside of the panel near the panel cut-out, to increase the strength of the panel.
Ensure all installation tolerances are maintained.
VICPAS supply MPCST11NDJ00T Magelis Schneider Touch screen panel glass and protective film with 365 Days warranty and support Urgent Worldwide Shipping.
Specifications:
The table below describes the parameters of the MPCST11NDJ00T Magelis Schneider Front Overlay Touch Screen.
| Part Number: | MPCST11NDJ00T |
| Display Type: | LCD TFT |
| Screen Diagonal: | 8.4 in |
| Warranty: | 365 Days |
| Product Line: | Magelis Smart Series |
| Terminal Type: | Touchscreen Display |
| Operating Temp.: | 0...50 °C |
| Storage Temp.: | -20...60 °C |
| Display Resolution: | 800 x 600 pixels SVGA |
| Operating System: | Windows XPe SP2 |
Related Magelis Schneider Smart Series Part No. :
| Magelis Smart Series | Description | Inventory status |
| XBTF011110 | Operator Terminals with 5.7-inch Operator Keypad | In Stock |
| Magelis Smart | Description | Inventory status |
Schneider Magelis Smart HMI Manuals PDF Download:
FAQ:
Question: How to Wire the Schneider Magelis Smart MPCST11NDJ00T Terminal Block?
Answer: When wiring and connecting the wires, be sure to follow the procedures given below:
1. Remove all power from the Smart 8.4" and confirm that the DC power supply has been disconnected from its power source.
2. Connect the power cord to the terminal block as shown below:
3. Place the terminal block in the power block and tighten the screws. The recommended torque to tighten these screws is 0.5 to 0.6 N•m (4.5 to 5.3 lb-in):
NOTE: The 24 Vdc power supply inside the DC-powered Smart units is protected by an 8 A fuse. This fuse is located inside the power supply and cannot be accessed or replaced by the user.
Question: What is the size of MPCST11NDJ00T Protective Film HMI Panel Glass?
Answer: The Schneider Terminal MPCST11NDJ00T Touch Screen Monitor Front Overlay is 8.4-inch.
Common misspellings:
MPCST11NJ00TPCST11NDJ00T
MPCST11DNJ00T
MPCS711NDJ00T
MPCST111NDJ00T
- Loading...
- Tel
- *Title
- *Content
Fast Quote
Fast Quote
Worldwide Shipping
12 Months Warranty
Customize Service
- Tel
- *Title
- *Content
